This header will fit, right? Options

[HectortheRican]

I know it'll fit my 7A, but it doesn't have the little "will fit Celica" fine print so I just wanna clear it before I spend money on it because that put the 0.01% of doubt in my mind that'll make me uneasy. Thanks guys.

http://cgi.ebay.com/ebaymotors/TOYOTA-CORO...sQ5fAccessories

[rave2n]

My ebay headers from Race daddy or some junk like that, bolted right to the block. As said, it was short from the second cat, and had to have it welded. Cost me 75 bucks.

This post has been edited by rave2n: Jul 19, 2010 - 7:52 PM

[mgnt232]

mine was from race daddy too! but mine was a worse fitment lol.
All the holes on the header to the block were too small, had to drill them out. came out about 8" short from the 2nd cat, and I had to cut off the piece at the very end of the downpipe, because the "in" on the cat is 1.75" and the piece at the end of the headers downpipe is 2". So I had to cut it off to make it sit flush, and just used some cheap exhaust sealer and extended the pipe obviously.
If you do it your self it ends up a $20 project for piping and sealant . but it is a pain! so if you have the money go to an exhaust shop, but if not its not tooo hard, just need the time, and I can tell you exactly what I had to do, which save alot! of time.